Custom map tint lvl reset ?

[SPIFFEN]

It would be nice to be abel to reset the level of the tint ,
so the tint lvl goes back to preset lvl .

An reset button after all the lvls in the map editor .

This will also make it easyier to improve the map your making ,
so you dont have to start over and the map doesnt turn out as good as it could be .

[SPIFFEN]

And it would be nice to change tint lvl for each square of the map ,
then we can make diffrent lvls of the terrain look flat ,
even when there is an small pillar in the way for towers .

Then the expert map makers can make better expert maps =P

[SPIFFEN]

Energy and Creepers colors should also have an rest button .

[UpperKEES]

so you dont have to start over

I also needed to reset some of these values in the past (after playing too much with them). The easiest way at the moment is to save your map and write down the values of a new map (the colours are values as well). Then re-open your map and enter the defaults yourself. Not as easy, but at least a solution without re-creating your map completely.

[SPIFFEN]

Yes that could be done =)
But so far i have exit the map editor so those maps has ended in the trash =(
I usally dont have patient to really redo an map to many times ,
so i make another map instead =P

And now i have an habbit of making maps that dont need to much work to be finnished ;)
But that might change if an reset button after everything in the mission settings are added .