User Tools
4rpl:commands:self
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| 4rpl:commands:self [2021/03/03 08:54] – typo Karsten75 | 4rpl:commands:self [2021/03/17 19:36] (current) – Note on COlsole and Global Control Karsten75 | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| Pushes the UID of the current unit to the stack. A unit UID is needed by many commands to determine which unit to act on. ' | Pushes the UID of the current unit to the stack. A unit UID is needed by many commands to determine which unit to act on. ' | ||
| executing script is attached to. Note that unit UID's are permanent and persist over save/load. | executing script is attached to. Note that unit UID's are permanent and persist over save/load. | ||
| + | |||
| + | Note: When run in Console scripts, or in Global Control (Pre or Post), -1 is returned. | ||
| ===== Examples ===== | ===== Examples ===== | ||
4rpl/commands/self.1614779660.txt.gz · Last modified: 2021/03/03 08:54 by Karsten75
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
