User Tools
crpl:docs:setcreeperflowrateondigitalis
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| crpl:docs:setcreeperflowrateondigitalis [2015/03/10 07:23] – more detail warren | crpl:docs:setcreeperflowrateondigitalis [2021/02/05 11:44] (current) – Rmoved discussion tag Karsten75 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ~~DISCUSSION~~ | + | |
| <- [[crpl: | <- [[crpl: | ||
| ===== SetCreeperFlowRateOnDigitalis | ===== SetCreeperFlowRateOnDigitalis | ||
| Line 10: | Line 10: | ||
| Sets the creeper flow rate on digitalis. 1.0 is the normal flow rate on digitalis. Lower means slower flow, higher means faster flow. You can't change this value for a single cell only. | Sets the creeper flow rate on digitalis. 1.0 is the normal flow rate on digitalis. Lower means slower flow, higher means faster flow. You can't change this value for a single cell only. | ||
| - | The number indicates the amount of a share that gets transferred to neighbour cells. 1.0 indicates that each neighbour gets one fifth of the creeper per frame, leaving one fifth in the cell. 0.2 would indicate that one twenty fifth goes to each neighbour per frame, leaving | + | The number indicates the amount of a share that gets transferred to neighbour cells. 1.0 indicates that each neighbour gets one fifth of the creeper per frame, leaving one fifth in the cell. 0.2 would indicate that one twenty fifth goes to each neighbour per frame, leaving |
| === Examples === | === Examples === | ||
| < | < | ||
crpl/docs/setcreeperflowrateondigitalis.1425986634.txt.gz · Last modified: 2015/03/10 07:23 by warren
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
