Knuckle Cracker Wiki

Sets the creeper flow rate on digitalis. 1.0 is the normal flow rate on digitalis. Lower means slower flow, higher means faster flow. You can't change this value for a single cell only.

The number indicates the amount of a share that gets transferred to neighbour cells. 1.0 indicates that each neighbour gets one fifth of the creeper per frame, leaving one fifth in the cell. 0.2 would indicate that one twenty fifth goes to each neighbour per frame, leaving twenty one twenty fifths in the original square. For this reason, if the flow rate is set above 1.25, weird things happen.

SetCreeperFlowRateOnDigitalis(0.07)