User Tools
4rpl:commands:setbeamend
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| 4rpl:commands:setbeamend [2021/04/15 12:27] – Karsten75 | 4rpl:commands:setbeamend [2022/05/25 18:23] (current) – [Description] Continuous beams in motion. Vertu | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| For a beam that is attached to a unit, the end position REMAINS IN WORLD COORDINATES unless the beam has been set to SetBeamForceLocalEnd. | For a beam that is attached to a unit, the end position REMAINS IN WORLD COORDINATES unless the beam has been set to SetBeamForceLocalEnd. | ||
| + | **Important note:** If you are planning to create a continuous beam on a unit that will be moving while firing, do not attach the beam to the unit. An attached beam will be unable to maintain the correct visual orientation and length. An unattached beam so long as its' start location is updated will retain a correct visual orientation. | ||
| ===== Examples ===== | ===== Examples ===== | ||
| <code 4rpl> | <code 4rpl> | ||
4rpl/commands/setbeamend.txt · Last modified: 2022/05/25 18:23 by Vertu
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
