User Tools
4rpl:commands:setsoylentcount
⇐ Index
Available in version 1.3 and later.
SetSoylentCount
SetSoylentCount(<-count)
Description
Sets the maximum number of soylent cells to deploy per interval. The default is 1. If you set this to higher than the max number of soylent cells around a tower, then a tower will deploy all available cells at once. This is similar to setting the soylent delay to 0. Note that if you set the soylent delay to 0, this value is ignored.
Examples
SetSoylentCount(5)
⇐ Index
4rpl/commands/setsoylentcount.txt · Last modified: 2021/02/06 14:17 by Regallion
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
