There are many versions of the PAC (PlayAsCreeper) scripts, but they all share some basic similarities:

1. Digitalis
   • Use brush to “paint” digitalis
   • E/R keys decrease/increase brush size
   • T key toggles: White brush creates, Red brush destroys
   • Digitalis can only be created in places where creeper depth is 1 or greater
   • Creating digitalis uses up some creeper
   • Colors
     • White: dead - won't hold creeper or spread
     • Blue: living - holds creeper, will spread to any white digitalis over time
     • Red: damaged - still holds creeper, but
   • Digitalis needs to be connected to an emitter to live
2. Emitter
   • Create on a PZ (PowerZone) that has LIVE creeper at the center
   • E/R keys change emitter between modes, both modes average the same amount/sec
     • normal: release every 0.5 seconds
     • burst: release after building up 400 creeper (usually 400, can be a different amount depending on map)
     • Burst mode is the preferred mode, except in rare cases where you need creeper ASAP
   • Emitters can be linked, the supporting emitter adds its strength to the supported (but it still maintains digitalis)
   • An emitter that is supported gains a weak field that helps push creeper ahead of it
   • T key will make all other emitters support the selected emitter
   • Shift-X destroys an emitter. This damages the digitalis beneath it, so it takes time before a new emitter/spore tower can be created there
3. Spore (tower)