crpl:docs:setcreeperflowrateondigitalis
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| crpl:docs:setcreeperflowrateondigitalis [2014/10/01 19:02] – external edit 127.0.0.1 | crpl:docs:setcreeperflowrateondigitalis [2025/02/14 14:57] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ~~DISCUSSION~~ | + | |
| <- [[crpl: | <- [[crpl: | ||
| ===== SetCreeperFlowRateOnDigitalis | ===== SetCreeperFlowRateOnDigitalis | ||
| Line 8: | Line 8: | ||
| === Description === | === Description === | ||
| - | Sets the creeper flow rate on digitalis. 0.2 is the normal flow rate (off digitalis). Lower means slower flow, higher means faster flow. You can't change this value for a single cell only. | + | Sets the creeper flow rate on digitalis. 1.0 is the normal flow rate on digitalis. Lower means slower flow, higher means faster flow. You can't change this value for a single cell only. |
| + | |||
| + | The number indicates the amount of a share that gets transferred to neighbour cells. 1.0 indicates that each neighbour gets one fifth of the creeper per frame, leaving one fifth in the cell. 0.2 would indicate that one twenty fifth goes to each neighbour per frame, leaving twenty one twenty fifths in the original square. For this reason, if the flow rate is set above 1.25, weird things happen. | ||
| === Examples === | === Examples === | ||
| < | < | ||
crpl/docs/setcreeperflowrateondigitalis.1412190170.txt.gz · Last modified: 2025/02/14 14:56 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
