crpl:docs:setcreeperflowrate
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| crpl:docs:setcreeperflowrate [2014/10/01 19:02] – external edit 127.0.0.1 | crpl:docs:setcreeperflowrate [2025/02/14 14:57] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ~~DISCUSSION~~ | + | ~~DISCUSSION:off~~ |
| <- [[crpl: | <- [[crpl: | ||
| ===== SetCreeperFlowRate | ===== SetCreeperFlowRate | ||
| Line 9: | Line 9: | ||
| === Description === | === Description === | ||
| Sets the creeper flow rate. 0.2 is normal. Lower means slower flow, higher means faster flow. You can't change this value for a single cell only. | Sets the creeper flow rate. 0.2 is normal. Lower means slower flow, higher means faster flow. You can't change this value for a single cell only. | ||
| + | |||
| + | |||
| + | The number indicates the amount of a share that gets transferred to neighbour cells. 1.0 indicates that each neighbour gets one fifth (1/5) of the creeper per frame, leaving one fifth (1/5) in the cell. 0.2 would indicate that one twenty fifth (1/25) goes to each neighbour per frame, leaving twenty one twenty fifths (21/25) in the original square. For this reason, if the flow rate is set above 1.25, weird things happen. | ||
| + | |||
| === Examples === | === Examples === | ||
| < | < | ||
crpl/docs/setcreeperflowrate.1412190170.txt.gz · Last modified: 2025/02/14 14:56 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
