4rpl:commands:createunit
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 4rpl:commands:createunit [2023/09/16 17:20] – Spore note. Vertu | 4rpl:commands:createunit [2025/02/14 14:57] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ===== Description ===== | ===== Description ===== | ||
| - | Creates a unit from a CMOD UID (a unit template defined in a CPACK). You can get the CMOD UID from within the CPACK manager. | + | Creates a unit from a CMOD UID (a unit template defined in a CPACK referred to as GUID). You can get the GUID from within the CPACK manager. |
| The unit will be placed at the supplied 3D vector position.\\ | The unit will be placed at the supplied 3D vector position.\\ | ||
| The initParams are a table that contains a set of variables that will be set on the newly created unit. See [[GetUnitSettings]] for a list of the data names that can be specified in the initData table when creating built in units.\\ | The initParams are a table that contains a set of variables that will be set on the newly created unit. See [[GetUnitSettings]] for a list of the data names that can be specified in the initData table when creating built in units.\\ | ||
4rpl/commands/createunit.1694884820.txt.gz · Last modified: 2025/02/14 14:56 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
