User Tools
4rpl:commands:setcreepercutoff
This is an old revision of the document!
⇐ Index
SetCreeperCutoff
SetCreeperCutoff(<-creeperCutoff)
Description
Sets the cutoff level for emitting creeper. This is the value show in the “emit mode” vertical chart next too the creeper graph. The value represents the average creeper per map cell. The value includes the entire surface area of the map, including void.
Examples
SetCreeperCutoff(4.5)
⇐ Index
4rpl/commands/setcreepercutoff.1611515566.txt.gz · Last modified: 2021/01/24 14:12 by Sanian
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
